PRODUCTS CENTER
Cable Trunking Division
Cable Trunking Division
Keywords：
Machining
Category：
Trunking Division
Hot-line：
Details
Cable tray system is made up of cable tray, cable tray bend, bracket, corbel, accessories etc. It used to support the cable in the process of installation and laying. Cable tray is divided into solid trough & cable trunking, cable ladder, ventilated & perforated trough, large span type etc.
Model and Design of cable trunking
1. Elect the environment conditions.Usually there are three kinds of environment conditions; one is corroding environment, such as alkaline-chlorine factories, another is usual environment, that is regular environment, such as air corrosion the third is special environment, such as exhibition rooms.
2. Decide the fixing method: suspension type, vertical type (these two types both may adopt single side fixing method or double-side fixing method) , wall-side type and etc Of the bridge according to the trend of the cable and the surroundings of the installation.
The advantages of cable trunking
1. Low cost, significant cost savings compared to standard traditional tray products.
2. Light in weight, wide range of sizes.
3. Fast heat dispersion.
4. Strong enough to withstand short circuits. Provides strength, rigidity without additional hardware.
5. Adapts to difficult architectural designs to accommodate changes in direction and elevation of cable runs.
6.Flexible, easy and fast installation. Design allows cable exit or entry at any point.
7. Safe smooth edge design to protect cable.
8.Easy for line check and cleaning , easy maintained.
Electric Remote Control Enclosure Panel Assembly Table
The Electric Remote Control Assembly Table is a mobile, battery-powered ergonomic workstation engineered for enclosure panel machining, assembly, wiring, and testing. Designed for switchgear manufacturers and panel builders, this assembly frame eliminates manual cranking and reduces operator fatigue with full electric remote control of both tilt and lift functions. The quick-release fastener system secures mounting plates in seconds, while four locking castors provide stable, cable-free mobility anywhere on the shop floor. Supporting panels up to 1008 × 2026 mm and a tilt range of 0°–68°, it is the ideal solution for workshops seeking to boost throughput, improve safety, and streamline enclosure production.
Cable Trunking Division
Ceiling air diffuser
Messages
One-Stop production factory